Step 1: Initially unplug your music system.
Step2: Now disconnect your speaker wire from the music/home theater system. As you go through the cable you can observe that the wire originating from each speaker consists of two metal wires covered by flexible latex which works as insulator.
7 Inch Car Tv
One wire is the ground, while the other is the positive. The tips of the wire towards the Y junction must be peeled up to half inch.
Step 3: Buy some roll of wire the matches the one which is same as your speaker cable. This information is given in the literature of your system or some times written on the cable itself. Along with these buy some wire connectors or nuts and electricians vinyl tape.
Step 4: According to the distance you want the speakers to be from them system, cut the purchased wire. Then make a Y junction by splitting the ends of the wire. Remove the insulation over the metal wire up to half - inch.
Step 5: The only thing you have to do is to connect the old set and the new set of wires. It can be done in many ways. Among all soldering these two wires is the best option but a bit unsafe if you are soldering it for the first time. Using wire nuts is the best option in such cases.
Step 6: You can follow the same steps for multiple speakers.
Step 7: Finally you have to connect the extended wires to the amplifier. Generally the positive goes into the red one and the ground wire goes into the black one
Reconnect your system and enjoy music or movie of your choice.